Steed Cycles
OneUp Dropper Post Remote V2 - Shimano I-SPEC II - Steed Cycles

OneUp Dropper Post Remote V2 - Shimano I-SPEC II

  • $64.99


A BETTER REMOTE FOR ANY CABLE OPERATED DROPPER

An Aluminum remote with an oversized bearing and a super smooth action. The unique lever position allows you to keep a stronger grip on the bars while actuating your post. Don't think twice about dropping your post, even when charging into technical sections. The OneUp lever mimics your R/H shifter’s inboard upshift paddle position instead of the usual downshift paddle position of most remotes. This position requires considerably less thumb movement to reach the lever.

NO BLEEDING

The cable setup is quick and easy. The cable clamps at the lever making shortening the housing length for clean routing a breeze. Unlike a hydraulically actuated dropper, there is no temperature sensitivity and If your remote gets damaged you can still lower or extend your post by removing it from your frame and pushing on the actuator by hand.

Kit includes cable and housing 

Compatible with all cable actuated dropper posts. 

SPECIFICATIONS

Shimano I-spec II Compatibility: - 11 speed XTR M9000, XT M8000, SLX M7000 only

Weight: Remote with Shimano I-spec II - 41g

SHIMANO I-SPEC II INSTALL INSTRUCTIONS

 (11speed M9000, M8000, M6000 only)
  • Remove the lever mounting bolt completely from the left brake using a 4mm hex
  • Depress the "Push to Open" button using a 2mm hex to fully open the brake lever clamp
  • Remove the plastic spacer from the inside of the lever clamp
  • Install the OneUp I-spec II adapter into the lever clamp
  • Loosely reinstall the brake lever clamp onto the handlebar
  • Attach the remote body to the I-spec II adapter using your preferred mounting hole.
  • Torque the remote body to the I-spec II adapter using a 4mm hex to 3Nm
  • Rotate the OneUp dropper remote until the remote body is parallel to the brake lever.
  • Torque the brake lever clamp to the manufacturer's recommendation